How to replace the filters in a Dyson Ball DC24 vacuum cleaner

If your Dyson DC24 Vacuum Cleaner isn't working as efficiently as usual, it may be that the filters need to be cleaned. This video shows how to remove Dyson DC24 vacuum filters so that they can be cleaned and replaced.

What you'll need: Dyson Ball Filters

Video Transcript: How to remove the filters from a Dyson DC24 ball vacuum

IMPORTANT: BEFORE REPLACING A PART IN ANY ELECTRICAL APPLIANCE, YOU MUST ENSURE THAT THE APPLIANCE IS FIRST UNPLUGGED FROM THE MAINS

The first filter is in the top of the cyclone body, which you will need to remove by unclipping.

Unclip the tab marked 'Filter A', and remove the filter from inside. The filter is now ready to be cleaned.

Filters should not be put back into the vacuum until they're completely dry, so we recommend to have a spare set for use while one set is drying out.

The second filter is inside the ball. To get to it you need to first lower the vacuum's handle, and rotate the ball until you see the arrow indicating where it can be opened up.

Press the arrow in, and a section of the covering will slide off, revealing the filter inside. Press the red button to release the filter, and pull it out.

This filter can now be cleaned and replaced.

To replace the filter, depress the button to click it back into place, position the front panel back onto the ball, and pull the handle back up.

Get the Part: View our range of Dyson spares

* All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.