How to change the filters in a Dyson DC08 vacuum cleaner

If your Dyson DC08 Vacuum Cleaner isn't working as efficiently as usual, it may be that the filters need to be cleaned. This video shows how to remove Dyson DC08 vacuum filters so that they can be cleaned and replaced.

What you'll need: Dyson DC08 filter

Video Transcript: How to change the filters in a Dyson DC08 vacuum cleaner

IMPORTANT: BEFORE REPLACING A PART IN ANY ELECTRICAL APPLIANCE, YOU MUST ENSURE THAT THE APPLIANCE IS FIRST UNPLUGGED FROM THE MAINS

Welcome to Buyspares. This video will show you how to change the filters in a Dyson Vacuum Cleaner.

Start by removing the cyclone body, by pressing the clip.

Release the catch on the filter cover shown here, to open up the filter covering.

Remove the filter by lifting it out and separate the two parts which can then be washed in warm soapy water and rinsed thoroughly.

Filters should not be put back into the vacuum until they're completely dry, so we recommend to have a spare set for use while one set is drying out.

To replace the filter, reset the two parts back together, place back in the unit and clip the lid shut.

Replace the cyclone body and click it back into place.

Get the Part: View our range of Dyson Spares

* All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.