How to Replace the Brushroll on a Gtech Sweeper

The following is a description for replacing the brush roll and edge wheel on a Gtech SW04 sweeper.

Please note that this may act as a general guide for other models, but the process may vary and it is always advisable to consult the instruction manual.

For information on how to tackle and resolve faults and problems on a wide range of appliances see our other articles »

The edge wheel and brushroll on your Gtech sweeper can be removed for cleaning and replacement purposes.

It is possible that during operation you may accidentally vacuum up hair or thread that becomes tangled around the brushroll, this can cause a blockage and stop the sweeper working efficiently.

To avoid this developing into a serious fault, it is advisable that you clear any blockage as soon as possible.

How to Replace The Edge Wheel and Brushroll on a Gtech sweeper:

1. Push the latch and un-hook the edge wheel cover.

2. Slide the belt off the end of the brush roll drive gear.

3. Lift and slide the brush roll out of the unit.

4. You can then push the edge wheel out of the cover.

5. Remove tangled thread or blockage from the brush roll.

6. Replace the brush roll by fitting the shaft into the bearing in the housing, and then engage the end with the drive gear into the unit. Note: peg to relocate into unit.

7. Refit the belt and edge wheel.

8. Push into place until the latch is securely engaged.

Buy a replacement Gtech sweeper brush roll or any other Gtech parts you need.

Get the Part: View our range of Gtech Sweeper Spares

* All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.