For information on how to confirm a fault on a cooker, oven or hob see our other articles.
Welcome to BuySpares, In this video we will show how to change the door catch on a Belling oven.
IMPORTANT: BEFORE REPLACING A PART IN ANY ELECTRICAL APPLIANCE, YOU MUST ENSURE THAT THE APPLIANCE IS FIRST UNPLUGGED FROM THE MAINS
Start by removing the side panel by taking out these screws here.
Next undo the catch screws and lift off.
Fit the new catch in position and screw in place.
Note: on some catches you may think the screw threads have not been machined.
This is normal as the screws used actually cut their own threads as they are screwed in.
Check the lock alignment by closing and opening the door and adjust the catch height or the striker pin as required.
Finally refit the side panel and reconnect the cooker and test.
For all the spares you need visit the buyspares website.
* All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.