How to Repair a Numatic Vacuum Cleaner Hose

The Numatic vacuum range includes models like Henry, Hetty, Basil and James. The hose ends can wear or get damaged but can easily be replaced by following this video.

Video Transcript: How to Repair a Numatic Vacuum Cleaner Hose

Welcome to BuySpares. In this video we will show you how to replace the hose ends on Numatic cleaners.

Important: Before replacing a part in any electrical appliance you must ensure that the appliance is first disconnected from the mains.

If the ends of the hose are damaged on your Numatic cleaner they can be replaced.

Using a sharp knife carefully cut off the end being replaced.

To fit put this top collar on to the pipe.

Screw the threaded boss onto the spiral of the hose.

Then fit the hose end and collar together, ensuring the locking tabs are located correctly.

The machine end is the same process.

Carefully cut the hose to give a square end.

Fit the outer collar onto the hose and screw the boss onto the spiral of the hose.

Fix the collar and the machine connecter together ensuring the locking tabs are located correctly.

You can then reattach the hose to the machine.

If the fittings come loose add a little contact adhesive to the threaded areas.

For all the spares you need visit www.buyspares.co.uk

* All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.