Order by Phone: 0844 557 5575 | 7p per min + your network access charge

    Order by Phone: 0844 557 5575 | 7p per min + your network access charge

    UK Next day delivery available Monday-Friday until 6pm UK Next day delivery available Monday-Friday until 6pm

    Replacing a Washer Dryer Heater Element (Hotpoint-Indesit)

    If your washer dryer is not heating during the drying cycle, the heater may have failed.We will show how to replace it.

    For information on how to tackle and resolve faults and problems on a wide range of appliances see our other articles »

    Tools that you will need

    Video Transcript: Replacing a Washer Dryer Heater Element (Hotpoint-Indesit) .

    Welcome to BuySpares.

    In this video we are showing you how to replace a dryer heating element on Hotpoint or Indesit washer dryer.

    Important: before replacing a part in any electrical appliance, you must ensure that the appliance is first.

    Take the top panel of by removing these two screws. Remove the bracket, and cut the cable tie before sliding off the door seal from the heater tunnel.

    Take out the screws around the tunnels edge. Disconnect the wires from the heating element and part the heater tunnel, using a screwdriver if needed.

    Remove the old element and replace it if it’s faulty.

    Ensure the rubber gasket is in the correct position, before refitting the heater cover.

    Refit the door seal and the connectors to the heater. Finally refit the cover and run a test cycle.

    For all the spares, you need visit www.buyspares.co.uk

    * All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.