How to Replace a Zanussi Tumble Dryer Belt Pulley.

A worn belt pulley may cause a squealing noise when the drum turns or can cause the drive belt to come off. This video shows how to change the pulley on a Zanussi tumble dryer.This type of dryer may also be sold under the brands of AEG, Electrolux, Tricity or John Lewis.

For information on how to tackle and resolve faults and problems on a wide range of appliances see our other articles »

Tools that you will need

How to Replace a Zanussi Tumble Dryer Belt Pulley.

Welcome to BuySpares, in this video we will show how to change a belt tension pulley on a Zanussi tumble dryer.

Important: Before replacing a part in any electrical appliance, you must ensure that the appliance is first unplugged from the mains.

A worn pulley may be noisy or even cause the belt to come off, so it should be replaced.

Start by removing the top panel, undo these screws and lift it off.

Remove these screws and take off this side panel.

Take off the fan cover by removing this screw and prising here.

Remove the nut and washer from the spindle while holding the fan and then push the fan off.

Release the tension spring on the motor and ease the belt off,

Then rotate the motor and remove the old pulley.

Put the new pulley on, turn the motor to refit the belt and then reconnect the tension spring.

Turn the drum to settle the belt.

Then refit the fan and its cover.

Refit the cabinet's parts and run a test cycle if required.

For all the spares you need visit the BuySpares website.

* All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.

  • Trusted Shops Guarantee
  • PayPal Accepted
  • Payment Options
CloseClose BuySpares

0844 557 5575

Contact Centre opening times

Monday - Friday9am - 5.30pm

Saturday - SundayClosed

Alternatively, click here to contact us via email

Calls to 0844 numbers will be charged at 7p per minute plus your network charge.