How to Get Started With Your New Karcher Pressure Washer

    If you have a new Karcher pressure washer, you'll want to know how to set it up. This video shows you how to get started with a Karcher pressure washer.

    For information on how to repair Pressure washer problems see our other articles ».

    Tools that you will need

    • No special tools required for this product

    Video Transcript: How to Get Started With Your New Karcher


    IMPORTANT: BEFORE REPLACING A PART IN ANY ELECTRICAL APPLIANCE, YOU MUST ENSURE THAT THE APPLIANCE IS FIRST UNPLUGGED FROM THE MAINS.

    Today we will show you how to get started with your new Karcher pressure washer.

    Once your Karcher is unpackaged the only things you need are an outside tap and a power supply.

    Connect the high-pressure hose to the gun by pulling out the c-clip, inserting the hose like this and replacing the clip, pushing it in securely.

    Make sure the hose pipe is fully extended from the reel with no kinks, and the power lead is fully unwound.

    Screw the male connector on to the machine like this and connect the female connector from the hose on to the male connector.

    Before switching the machine on, you need to expel all the trapped air by bleeding through with water.

    Connect the hose to the front of the machine. Connect the lance on to the hose by pushing in and turning to lock in place, your Karcher pressure washer is now ready to use.

    When using any electrical tools in the garden always use a RCD safety device

    * All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.