How to Replace a PCB in a Tumble Dryer (Hoover)

If your tumble dryer is dead and you have identified it has a faulty control board, you will need to replace the part. In This video, we show you how to replace the PCB in your tumble dryer.

For information on how to tackle and resolve faults and problems on a wide range of appliances see our other articles »

Tools that you will need

Screwdriver: Philips or crosspoint type »

Screwdriver: flat blade type »

Parts that you will need

Hoover Tumble Dryer Spares»

Tumble Dryer Balls »

Tumble Dryer Spare Parts »

Video Transcript: How to replace a PCB in a Tumble Dryer (Hoover)

Welcome to BuySpares, in this video we'll show you how to replace a PCB in a Hoover tumble dryer.

Important: before replacing a part in any electrical appliance, you must ensure that the appliance is first unplugged from the mains.

If your machine is not powering up and you have identified a control board problem you may need to replace it.

Remove the cabinet top by removing the three screws, slide it back and then unscrew the control panel.

Disconnect the PCB connectors and lift off the panel.

Fit the new PCB, and refit the connectors.

Refit the control panel.

For all the spares you need visit www.buyspares.co.uk

* All information provided is a guide only. BuySpares accepts no liability for any problems occurred while attempting any advice shown. If in any doubt contact a qualified repair service.